Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) - Manual (Page 682)

654 Multi-Service IronWare Routing Configuration Guide
53-1003033-02
Configuring OSPFv3
The device selects one route over another based on the source of the route information. To do so,
the device can use the administrative distances assigned to the sources. You can influence the
device’s decision by changing the default administrative distance for OSPFv3 routes.
Configuring administrative distance based on route type
You can configure a unique administrative distance for each type of OSPFv3 route. For example,
you can use this feature to influence the device to prefer a static route over an OSPF inter-area
route and to prefer OSPF intra-area routes to static routes.
The distance you specify influences the choice of routes when the device has multiple routes to the
same network from different protocols. The device prefers the route with the lower administrative
distance.
You can specify unique default administrative distances for the following OSPFv3 route types:
• Intra-area routes
• Inter-area routes
• External routes
The default for all of these OSPFv3 route types is 110.
NOTE
This feature does not influence the choice of routes within OSPFv3. For example, an OSPF intra-area
route is always preferred over an OSPF inter-area route, even if the intra-area route’s distance is
greater than the inter-area route’s distance.
For example, to change the default administrative distances for intra-area routes to 80, inter-area
routes to 90, and external routes to 100, enter the following commands.
Brocade(config-ospf6-router)# distance intra-area 80
Brocade(config-ospf6-router)# distance inter-area 90
Brocade(config-ospf6-router)# distance external 100
Syntax: distance external | inter-area | intra-area distance
The external | inter-area | intra-area keywords specify the route type for which you are changing
the default administrative distance.
The distance parameter specifies the new distance for the specified route type. You can specify a
value from
1 – 255.
To reset the administrative distance of a route type to its system default, enter the no form of this
command.
Configuring the OSPFv3 LSA pacing interval
The device paces OSPFv3 LSA refreshes by delaying the refreshes for a specified time interval
instead of performing a refresh each time an individual LSA’s refresh timer expires. The
accumulated LSAs constitute a group, which the device refreshes and sends out together in one or
more packets.