beautypg.com

Modify ospf traps generated, Displaying the configured ip prefix list – Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) User Manual

Page 234

background image

206

Multi-Service IronWare Routing Configuration Guide

53-1003033-02

Adding additional parameters

Brocade(config)# show ip ospf config

Router OSPF: Enabled

Graceful Restart: Disabled, timer 120

Graceful Restart Helper: Enabled

Redistribution: Disabled

Default OSPF Metric: 10

OSPF Auto-cost Reference Bandwidth: Disabled

OSPF Redistribution Metric: Type2

OSPF External LSA Limit: 14447047

OSPF Database Overflow Interval: 0

RFC 1583 Compatibility: Enabled

Router id: 10.5.5.1

Interface State Change Trap: Enabled

Virtual Interface State Change Trap: Enabled

Neighbor State Change Trap: Enabled

Virtual Neighbor State Change Trap: Enabled

Interface Configuration Error Trap: Enabled

Virtual Interface Configuration Error Trap: Enabled

Interface Authentication Failure Trap: Enabled

Virtual Interface Authentication Failure Trap: Enabled

Interface Receive Bad Packet Trap: Enabled

Virtual Interface Receive Bad Packet Trap: Enabled

Interface Retransmit Packet Trap: Disabled

Virtual Interface Retransmit Packet Trap: Disabled

Originate LSA Trap: Disabled

Originate MaxAge LSA Trap: Disabled

Link State Database Overflow Trap: Disabled

Link State Database Approaching Overflow Trap: Disabled

OSPF Area currently defined:

Area-ID Area-Type Cost Prefix List In Prefix List Out

0 normal 0

1 normal 0 Area_1_Pfx_list in Area_1_Pfx_List_Out

Syntax: show ip ospf config

DIsplaying the configured IP prefix list

To only display the configured ip prefix-list, enter a command such as the following.

Brocade# show ip prefix-lists

ip prefix-list abc: 2 entries

seq 5 deny 2.3.4.0/24

seq 10 permit 4.5.0.0/16.

Syntax: show ip prefix-lists [prefix-list-name ]

The prefix-list-name parameter specifies the name of the prefix list. You use this name when
applying the prefix list to an area.

Modify OSPF traps generated

OSPF traps as defined by RFC 1850 are supported on device.

You can disable all or specific OSPF trap generation by entering the following CLI command.

Brocade(config)# no snmp-server trap ospf

To later re-enable the trap feature, enter snmp-server trap ospf.

To disable a specific OSPF trap, enter the command as no snmp-server trap ospf ospf-trap.