Displaying ipv6 pbr information, Displaying ipv6 accounting information – Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) User Manual
Page 795

Multi-Service IronWare Routing Configuration Guide
767
53-1003033-02
Displaying IPv6 PBR information
Brocade(config-routemap v6pbr)#set next-hop-flood-vlan 200 outgoing-da
0000.0022.3333
Brocade(config-routemap v6pbr)#
Brocade(config-routemap v6pbr)#interface ethernet 2/2
Brocade(config-if-e10000-2/2)#ipv6 address 2001:db8::1/64
Brocade(config-if-e10000-2/2)#ipv6 enable
Brocade(config-if-e10000-2/2)#ipv6 policy route-map v6pbr
To allow normal routing for certain traffic, a corresponding deny ACL filter can be added before any
permit ACL filter.
Displaying IPv6 PBR information
The following sections describe the commands used to display the IPv6 ACL accounting information
and the route map information used in the IPv6 PBR configuration.
Displaying IPv6 accounting information
IPv6 PBR accounting is supported through the use of IPv6 ACL accounting in Brocade NetIron XMR
and Brocade MLX Series devices. ACL counters need to be enabled to view accounting data.
Brocade(config)#enable-acl-counter
Brocade# sh ipv6 access-list accounting brief policy-based-routing
IPv6 Policy Based Routing Accounting Summary: (ac = accumulated since
accounting started)
Int In ACL Total In Hit Out ACL Total Out Hit
2/6v6ACL1-udp 0(1s)
0(1m)
0(5m)
0(ac)
2/6v6ACL1-tcp 0(1s)
0(1m)
0(5m)
0(ac)
2/6ipv6-src-d 0(1s)
0(1m)
0(5m)
0(ac)
VE 40v6ACL1-udp 11659(1s)
700150(1m)
3500549(5m)
160277093(ac)
VE 40v6ACL1-tcp 127319(1s)
7645985(1m)
38227679(5m)
1750303054(ac)
Syntax: show ipv6 access-list accounting [brief | eth s/p |ve id] policy-based-routing
The brief option provides a brief display of the statistics. The eth s/p option provides Ethernet
statistics for the specified port. The ve id option provides VE statistics for the specified ID.