Ce 1 and ce 2 configurations, Ce 3 and ce 4 configurations – Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) User Manual
Page 408

380
Multi-Service IronWare Routing Configuration Guide
53-1003033-02
Configuring Multi-VRF
Brocade(config-if-e1000-1/3)# vrf forwarding green
Brocade(config-if-e1000-1/3)# ip ospf area 2
Brocade(config-if-e1000-1/3)# ip address 10.2.1.1/24
Brocade(config-if-e1000-1/3)# exit
Brocade(config)# interface ve 10
Brocade(config-vif-10)# vrf forwarding green
Brocade(config-vif-10)# ip ospf area 0
Brocade(config-vif-10)# ip address 10.3.1.1/24
Brocade(config-vif-10)# Interface ve 20
Brocade(config-vif-20)# vrf forwarding red
Brocade(config-vif-20)# ip ospf area 0
Brocade(config-vif-20)# ip address 10.3.1.1/24
CE 1 and CE 2 configurations
The CE1 and CE2 router configurations are exactly the same. Both are configured in OSPF Area 1
with route redistribution enabled. The IP addresses: 10.1.2.1/24 and 10.1.3.1/24 are configured
for the Loopback1 interface allowing them to carry routes from these networks.
Brocade(config)# router ospf
Brocade(config-ospf-router)# area 1
Brocade(config-ospf-router)# redistribution connected
Brocade(config-ospf-router)# exit
Brocade(config)# interface loopback 1
Brocade(config-lbif-1)# ip address 10.1.2.1/24
Brocade(config-lbif-1)# ip address 10.1.3.1/24
Brocade(config-lbif-1)# interface ethernet 1/1
Brocade(config-if-e1000-1/1)# ip ospf area 1
Brocade(config-if-e1000-1/1)# ip address 10.1.1.2/24
CE 3 and CE 4 configurations
The CE3 and CE4 router configurations are exactly the same. Both are configured in OSPF Area 2
with route redistribution enabled. The IP addresses: 10.2.2.1/24 and 10.2.3.1/24 are configured
for the Loopback1 interface allowing them to carry routes from these networks
Brocade(config)# router ospf
Brocade(config-ospf-router)# area 2
Brocade(config-ospf-router)# redistribution connected
Brocade(config-ospf-router)# exit
Brocade(config)# interface loopback 1
Brocade(config-lbif-1)# ip address 10.1.2.1/24
Brocade(config-lbif-1)# ip address 10.1.3.1/24
Brocade(config-lbif-1)# interface ethernet 1/1
Brocade(config-if-e1000-1/1)# ip ospf area 2
Brocade(config-if-e1000-1/1)# ip address