Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) - Manual (Page 444)

416 Multi-Service IronWare Routing Configuration Guide
53-1003033-02
IPv6 host support
Viewing IPv6 SNMP server addresses
Many show commands display IPv6 addresses for IPv6 SNMP servers. This example shows output
for the show snmp server command.
Disabling router advertisement and
solicitation messages
Router advertisement and solicitation messages enable a device to discover other devices on the
same link. By default, router advertisement and solicitation message generation is enabled. To
disable this feature, configure an IPv6 access list that denies them. Enter commands such as the
following.
Brocade(config)# ipv6 access-list rtradvert
Brocade(config-ipv6-access-list rtradvert)# deny icmp any any
router-advertisement
Brocade(config-ipv6-access-list rtradvert)# deny icmp any any router-solicitation
Brocade(config-ipv6-access-list rtradvert)# permit ipv6 any any
Brocade# show snmp server
Contact:
Location:
Community(ro): .....
Traps
Warm/Cold start: Enable
Link up: Enable
Link down: Enable
Authentication: Enable
Locked address violation: Enable
Power supply failure: Enable
Fan failure: Enable
Temperature warning: Enable
STP new root: Enable
STP topology change: Enable
vsrp: Enable
Total Trap-Receiver Entries: 4
Trap-Receiver IP-Address Port-Number Community
1 10.147.201.100 162 .....
2 2001:db8:4000::200 162 .....
3 10.147.202.100 162 .....
4 2001:db8:3000::200 162 .....