Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) - Manual (Page 679)

Multi-Service IronWare Routing Configuration Guide 651
53-1003033-02
Configuring OSPFv3
The following commands specify an IPv6 prefix list called filterOspfRoutesVe that denies route
2001:db8:3::/64.
Brocade(config)# ipv6 prefix-list filterOspfRoutesVe seq 5 deny 2001:db8:3::/64
Brocade(config)# ipv6 prefix-list filterOspfRoutesVe seq 10 permit ::/0 ge 1 le
128
The following commands configure a distribution list that applies the filterOspfRoutesVe prefix list
to routes pointing to virtual interface 10.
Brocade(config)# ipv6 router ospf
Brocade(config-ospf6-router)# distribute-list prefix-list filterOspfRoutesVe in
ve 10
After this distribution list is configured, route 2001:db8:3::/64, pointing to virtual interface 10,
would be omitted from the OSPFv3 route table.
Configuring an OSPFv3 distribution list using a route map as input
The following commands configure a route map that matches internal routes.
Brocade(config)# route-map allowInternalRoutes permit 10
Brocade(config-routemap allowInternalRoutes)# match route-type internal
The following commands configure a distribution list that applies the allowInternalRoutes route
map globally to OSPFv3 routes.
Brocade(config)# ipv6 router ospf
Brocade(config-ospf6-router)# distribute-list route-map allowinternalroutes in
Syntax: [no] distribute-list route-map name in
After this distribution list is configured, the internal routes would be included, and the external
routes would be omitted from the OSPFv3 route table.
Brocade# show ipv6 ospf route
Current Route count: 4
Intra: 3 Inter: 0 External: 1 (Type1 0/Type2 1)
Equal-cost multi-path: 0
Destination Options Area Cost Type2 Cost
Next Hop Router Outgoing Interface
*IA 2001:db8:1::/64 --------- 10.0.0.1 0 0
:: ve 10
*E2 2001:db8:2::/64 --------- 0.0.0.0 10 0
fe80::2e0:52ff:fe00:10 ve 10
*IA 2001:db8:4::/64 --------- 0.0.0.0 10 0
:: ve 11
*E2 2001:db8:5::/64 --------- 0.0.0.0 10 0
fe80::2e0:52ff:fe00:10 ve 10