Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) - Manual (Page 656)

628 Multi-Service IronWare Routing Configuration Guide
53-1003033-02
show ipv6 bgp vrf summary
show ipv6 bgp vrf summary
Displays the VRF6 summary statistics for all the VRF6 routes
Syntax show ipv6 bgp vrf vrf-name summary
Parameters vrf-name Specifies the VRF6 name whose summary statistics needs to be displayed.
Command
Modes
Privileged EXEC mode
Usage
Guidelines
The show ipv6 bgp vrf summary command displays the VRF6 summary statistics for all the VRF6
routes in the device’s BGP4+ route table for a specified VRF.
Command
Output
The show ipv6 bgp vrf summary command displays the following information:
Output field Description
Router ID The device’s ID.
Local AS Number The BGP4+ AS number for the device.
Confederation Identifier The AS number of the confederation in which the device resides.
Confederation Peers The numbers of the local ASs contained in the confederation. This list matches the
confederation peer list you configure on the device.
Maximum Number of IP
ECMP Path Supported for
Load Sharing The maximum number of IP ECMP route paths across which the device can balance
traffic to the same destination.
Number of Neighbors
Configured The number of BGP4+ neighbors configured on this device, and currently in
established state.
Number of Routes
Installed The number of BGP4+ routes in the device BGP4 route table and the route or path
memory usage.
Number of Routes
Advertising to All
Neighbors The total of the RtSent and RtToSend columns for all neighbors, the total number of
unique ribout group entries, and the amount of memory used by these groups.
Number of Attribute
Entries Installed The number of BGP4+ route-attribute entries in the device route-attributes table and
the amount of memory used by these entries.
Neighbor Address The IP addresses of the BGP4 neighbors for this device.
AS# The AS number.