Ospfv3 clear commands, Clearing all ospfv3 data, Clearing all ospfv3 packet counters – Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) User Manual
Page 731: Scheduling shortest path first (spf) calculation

Multi-Service IronWare Routing Configuration Guide
703
53-1003033-02
OSPFv3 clear commands
Use the show ipv6 ospf vrf neighbor command to display the currently selected neighbor for use by
the Virtual Links in each transit area.
OSPFv3 clear commands
The following OSPFv3 clear commands are supported.
Clearing all OSPFv3 data
You can use the ospf all command to clear all OSPF data by disabling and enabling the OSPFv3
processes as shown in the following.
Brocade# clear ipv6 ospf all
Syntax: clear ipv6 ospf all
Clearing all OSPFv3 packet counters
You can use the ospf traffic command to clear all OSPFv3 packet counters as shown in the
following.
Brocade# clear ipv6 ospf traffic
Syntax: clear ipv6 ospf traffic
Scheduling Shortest Path First (SPF) calculation
You can use the ospf force-spf command to perform the SPF calculation without clearing the OSPF
database, as shown in the following.
Brocade# clear ipv6 ospf force-spf
Syntax: clear ipv6 ospf force-spf
Brocade#sh ipv6 ospf vrf red neighbor
Total number of neighbors in all states: 1
Number of neighbors in state Full : 1
Type tx rx tx-byte rx-byte
Unknown 0 0 0 0
Hello 32 32 1276 1280
DbDesc 2 2 116 116
LSReq 1 1 52 52
LSUpdate 2 2 184 200
LSAck 2 2 112 112
OSPF messages dropped,no authentication: 0
Neighbor: State: Full Address: 2001:db8:1::1 Interface: eth 1/1