Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) - Manual (Page 345)

Multi-Service IronWare Routing Configuration Guide 317
53-1003033-02
RIP parameters and defaults
RIP interface parameters
Table 53 lists the interface-level RIP parameters and their default values, and indicates where you
can find configuration information.
Redistribution RIP can redistribute routes from other routing
protocols such as OSPF and BGP4 into RIP. A
redistributed route is one that a router learns through
another protocol, then distributes into RIP. Disabled page 319
Redistribution
metric RIP assigns a RIP metric (cost) to each external route
redistributed from another routing protocol into RIP.
This parameter applies to routes that are
redistributed from other protocols into RIP. 1 (one) page 321
Learning default
routes The Brocade device can learn default routes from its
RIP neighbors.
NOTE: You also can enable or disable this parameter
on an individual interface basis. Refer to
Table 53 on page 317.
Disabled page 321
Advertising and
learning with
specific
neighbors The Brocade device learns and advertises RIP routes
with all its neighbors by default. You can prevent the
Brocade device from advertising routes to specific
neighbors or learning routes from specific neighbors. Learning and
advertising permitted
for all neighbors page 322
TABLE 53 RIP interface parameters
Parameter Description Default See page...
RIP state and
version The state of the protocol and the version that is
supported on the interface. The version can be one of
the following:
•
Version 1 only
•
Version 2 only
•
Version 1, but also compatible with version 2
NOTE: : You also must enable RIP globally.
Disabled page 318
Metric A numeric cost the Brocade device adds to RIP routes
learned on the interface. This parameter applies only
to RIP routes. 1 (one) page 319
Learning default
routes Locally overrides the global setting. Refer to Table 52
on page 316.
Disabled page 321
TABLE 52 RIP global parameters (Continued)
Parameter Description Default See page...