Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) - Manual (Page 705)

Multi-Service IronWare Routing Configuration Guide 677
53-1003033-02
Displaying OSPFv3 information
Displaying IPv6 OSPFv3 interface information
IPv6 Interface information can be displayed in either a brief or full mode. The following sections
describe the command to display these modes and the resulting output:
• Displaying IPv6 OSPFv3 Interface Information in Brief Mode
• Displaying IPv6 OSPFv3 Interface Information in Full Mode
Displaying IPv6 OSPFv3 interface information in brief mode
You can use the following command to display a summary of IPv6 Interface information.
Syntax: show ipv6 ospf interface brief
This display shows the following information.
Stat/Prot Shows the status of the link and the protocol for the interface. The status can be
one of the following:
•
Up
•
Down
IGPs Shows the type of the Interior Gateway Protocols (IGPs) enabled on the interface.
IPv6 Address Shows the link local IPv6 address configured for the interface.
VRF Specifies the VRF type applied to the interface.
TABLE 135 Summary of OSPFv3 interface brief information
This field... Displays...
Interface The interface type, and the port number or number of the interface.
Area The OSPF area configured on the interface.
Status The status of the link and the protocol. Possible status include the following:
•
Up.
•
Down.
Type The type of OSPFv3 circuit running on the interface. Possible types include the following:
•
BCST- Broadcast interface type
•
P2P- Point-to-point interface type
•
UNK- The interface type is not known at this time
Cost The overhead required to send a packet across an interface.
TABLE 134 Summary of IPv6 interface information (Continued)
Field Description
Brocade# show ipv6 ospf interface brief
Interface Area Status Type Cost State Nbrs (F/C)
eth 1/1 0 up BCST 1 DROther 1/1
loopback 1 0 up BCST 1 Loopback 0/0