Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) - Manual (Page 796)

768 Multi-Service IronWare Routing Configuration Guide
53-1003033-02
Displaying IPv6 PBR information
Displaying IPv6 PBR route map information
Use the commands listed in the following sections to display the route map information used in the
IPv6 PBR configuration.
Displaying IPv6 route map information
To view the route map information, use the show route-map command.
Brocade# show route-map ipv6_pbr_map
route-map ipv6_pbr_map permit 10
match ipv6 address for_pbr_match_src
set ipv6 next-hop 2001:db8::1
Syntax: show route-map map-name
The map-name variable is the name of the PBR route map you want to view.
To view the route map binding information, use the show route-map binding command.
Brocade# show route-map binding ipv6_pbr_map
IPv6 Bindings of ipv6_pbr_map :
1/1
Syntax: show route-map binding [map-name]
The map-name variable is the name of the route map binding you want to view.
Displaying IPv6 ACL and route map information
on the Brocade NetIron CES and Brocade NetIron CER
Displaying IPv6 ACL output
To view the IPv6 ACL output on the Brocade NetIron CES and Brocade NetIron CER use the show
ipv6 access-list command.
Brocade# show ipv6 access-list ipv6acl
ipv6 access-list ipv6acl: 3 entries
10: permit enable-accounting ipv6 2001:db8:3::/64 2001:db8:4::/64
20: permit ipv6 2001:db8:3::/64 any
30: permit ipv6 any 2001:db8:4::/64
Syntax: show ipv6 access-list ACL list name
The ACL list name variable is the name of the ACL you want to view.
Displaying IPv6 route map output
To view the route map output on the Brocade NetIron CES and Brocade NetIron CER use the show
route-map command.
Brocade# show route-map pbr-1
route-map pbr-1 permit 5
match ipv6 address ipv6acl
set ipv6 next-hop 2001:db8:5::2
set ipv6 next-hop 2001:db8:5::3
set ipv6 next-hop 2001:db8:4::2