Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) - Manual (Page 170)

142 Multi-Service IronWare Routing Configuration Guide
53-1003033-02
Displaying BGP4 information
You can display all dampened routes by entering the show ip bgp dampened-paths.command.
Displaying the active route map configuration
You can view the active route map configuration (contained in the running configuration) without
displaying the entire running configuration.by entering the following command at any level of the
CLI.
Brocade# show route-map
route-map permitnet4 permit 10
match ip address prefix-list plist1
route-map permitnet1 permit 1
match ip address prefix-list plist2
route-map setcomm permit 1
set community 1234:2345 no-export
route-map test111 permit 111
match address-filters 11
set community 11:12 no-export
route-map permit1122 permit 12
match ip address 11
route-map permit1122 permit 13
match ip address std_22
This example shows that the running configuration contains six route maps. Notice that the match
and set statements within each route map are listed beneath the command for the route map
itself. In this simplified example, each route map contains only one match or set statement.
To display the active configuration for a specific route map, enter a command such as the following,
which specifies a route map name.
Brocade# show route-map setcomm
route-map setcomm permit 1
set community 1234:2345 no-export
This example shows the active configuration for a route map named “setcomm“.
Syntax: show route-map [map-name]