Displaying ospfv3 virtual neighbor information – Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) User Manual
Page 720

692
Multi-Service IronWare Routing Configuration Guide
53-1003033-02
Displaying OSPFv3 information
Syntax: show ipv6 ospf virtual-link
This display shows the following information.
Displaying OSPFv3 virtual neighbor information
To display OSPFv3 virtual neighbor information for the device, enter the following command at the
enabled level of the CLI.
Syntax: show ipv6 ospf virtual-neighbor [brief]
The [brief] option results in an output that omits the Option, QCount, and Timer fields. The
command output shows the following information.
TABLE 144
OSPFv3 virtual link information
This field...
Displays...
Index
An index number associated with the virtual link.
Transit Area ID
The ID of the shared area of two ABRs that serves as a connection point
between the two routers.
Router ID
Router ID of the router at the other end of the virtual link (virtual neighbor).
Interface Address
The local address used to communicate with the virtual neighbor.
State
The state of the virtual link. Possible states include the following:
•
P2P – The link is functioning as a point-to-point interface.
•
DOWN – The link is down.
TABLE 145
OSPFv3 virtual neighbor information
This field...
Displays...
Index
An index number associated with the virtual neighbor.
Router ID
IPv4 address of the virtual neighbor.
Address
The IPv6 address to be used for communication with the virtual neighbor.
Brocade# show ipv6 ospf virtual-link
Index Transit Area ID Router ID Interface Address State
1 1 10.1.1.1 201:db8::2 P2P
Brocade#show ipv6 ospf virtual-neighbor
Index Router ID Address State Interface
1 10.14.14.14 2001:db8:44:44::4 Full eth 1/8
Option: 00-00-00 QCount: 0 Timer: 408
2 10.14.14.14 2001:db8:44:44::4 Full tunnel 256
Option: 00-00-00 QCount: 0 Timer: 43