Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) - Manual (Page 145)

Multi-Service IronWare Routing Configuration Guide 117
53-1003033-02
Displaying BGP4 information
Displaying BGP4 information
You can display the following configuration information and statistics for BGP4 protocol:
• Summary BGP4 configuration information for the device
• Active BGP4 configuration information (the BGP4 information in the running configuration)
• Neighbor information
• Peer-group information
• Information about the paths from which BGP4 selects routes
• Summary BGP4 route information
• The device’s BGP4 route table
• Route flap dampening statistics
• Active route maps (the route map configuration information in the running configuration)
• BGP4 Restart Neighbor Information
• AS4 support and asdot notation
Displaying summary BGP4 information
You can display the local AS number, the maximum number of routes and neighbors supported,
and some BGP4 statistics. You can also display BGP4 memory usage for:
• BGP4 routes installed
• Routes advertising to all neighbors (aggregated into peer groups)
• Attribute entries installed
The show ip bgp summary command output has the following limitations:
• If a BGP4 peer is not configured for an address-family, the peer information is not displayed.
• If a BGP4 peer is configured for an address-family but not negotiated for an address-family
after the BGP4 peer is in the established state, the show ip bgp summary command output
shows (NoNeg) at the end of the line for this peer.
• If a BGP4 peer is configured and negotiated for that address-family, its display is the same as
in previous releases.
To view summary BGP4 information for the device, enter the following command at any CLI prompt
Syntax: show ip bgp summary
Brocade# show ip bgp summary
BGP4 Summary
Router ID: 10.10.1.14 Local AS Number: 100
Confederation Identifier: not configured
Confederation Peers:
Maximum Number of IP ECMP Paths Supported for Load Sharing: 1
Number of Neighbors Configured: 67, UP: 67
Number of Routes Installed: 258088, Uses 22195568 bytes
Number of Routes Advertising to All Neighbors: 17,035844 (3,099146 entries),
Uses 192,147052 bytes
Number of Attribute Entries Installed: 612223, Uses 55100070 bytes
Neighbor Address AS# State Time Rt:Accepted Filtered Sent ToSend
10.0.100.2 100 ESTABp 0h28m24s 0 0 258087 0
10.0.101.2 100 ESTAB 0h28m24s 0 0 258087 0
10.2.3.4 200 ADMDN 0h44m56s 0 0 0 2