Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) - Manual (Page 248)

220 Multi-Service IronWare Routing Configuration Guide
53-1003033-02
Displaying OSPF information
Displaying OSPF neighbor information
To display OSPF neighbor information, enter the following command at any CLI level.
Syntax: show ip ospf neighbor [router-id ip-addr | num | extensive]
The router-id ip-addr parameter displays only the neighbor entries for the specified router.
The num parameter displays only the entry in the specified index position in the neighbor table. For
example, if you enter “1”, only the first entry in the table is displayed.
The extensive option displays detailed information about the neighbor.
These displays show the following information.
LSA The LSA number.
Chksum(Hex) The checksum for the LSA packet. The checksum is based on all the fields in the
packet except the age field. The device uses the checksum to verify that the
packet is not corrupted.
TABLE 25 CLI display of OSPF neighbor information
Field Description
Port The port through which the device is connected to the neighbor.
Address The IP address of the port on which this device is connected to the neighbor.
Pri The OSPF priority of the neighbor.
•
For multi-access networks, the priority is used during election of the Designated Router (DR) and
Backup designated Router (BDR).
•
For point-to-point links, this field shows one of the following values:
•
1 = point-to-point link
•
3 = point-to-point link with assigned subnet
TABLE 24 CLI display of OSPF area information (Continued)
This field... Displays...
Brocade# show ip ospf neighbor
Port Address Pri State Neigh Address Neigh ID Ev Op Cnt
v10 10.1.10.1 1 FULL/DR 10.1.10.2 10.65.12.1 5 2 0
v11 10.1.11.1 1 FULL/DR 10.1.11.2 10.65.12.1 5 2 0
v12 10.1.12.1 1 FULL/DR 10.1.12.2 10.65.12.1 5 2 0
v13 10.1.13.1 1 FULL/DR 10.1.13.2 10.65.12.1 5 2 0
v14 10.1.14.1 1 FULL/DR 10.1.14.2 10.65.12.1 5 2 0