Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) - Manual (Page 241)

Multi-Service IronWare Routing Configuration Guide 213
53-1003033-02
Adding additional parameters
Brocade(config)# router ospf
Brocade(config-ospf-router)# max-metric router-lsa summary-lsa 16777214 link all
The following command turns off the advertisement of special metric values in all Router,
Summary, and External LSAs.
Brocade(config)# router ospf
Brocade(config-ospf-router)# no max-metric router-lsa
Configuring OSPF shortest path first throttling
To set OSPF shortest path first throttling to the values in the previous example, use the following
command.
Brocade(config-ospf-router)# timer throttle spf 200 300 2000
Syntax: [no] timer throttle spf initial-delay hold-time max-hold-time
The initial-delay variable sets the initial value for the SPF delay in milliseconds. Possible values are
between 0 and 65535 milliseconds.
The hold-time variable sets the minimum hold time between SPF calculations after the initial delay.
This value will be doubled after hold-time expires until the max-hold-time is reached. Possible
values are between 0 and 65535 milliseconds.
The max-hold-time variable sets the maximum hold time between SPF calculations Possible values
are between 0 and 65535 milliseconds.
NOTE
The hold time values that you specify are rounded up to the next highest 100 ms value. For example,
any value between 0 and 99 will be configured as 100 ms.
Command replacement
This command overlaps in functionality with the timer throttle spf command which will be phased
out from the Multi-Service IronWare software. To use this command to replicate the exact
functionality of the timer throttle spf command configure it as shown in the following.
Brocade(config-ospf-router)# timer throttle spf 1000 5000 5000
Displaying OSPF Router Advertisement
Using the show ip ospf command you can display the current OSPF Router Advertisement
configuration. The text show below in bold is displayed for an OSPF Router Advertisement
configuration.
Brocade#show ip ospf
OSPF Version Version 2
Router Id 10.10.10.10
ASBR Status No
ABR Status No (0)
Redistribute Ext Routes from
External LSA Counter 5
External LSA Checksum Sum 0002460e
Originate New LSA Counter 5
Rx New LSA Counter 8