Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) User Manual
Page 675
Multi-Service IronWare Routing Configuration Guide
647
53-1003033-02
Configuring OSPFv3
The route-map map-name parameter specifies the route map name. The following match
parameters are valid for OSPFv3 redistribution:
•
match ip address | next-hop acl-number
•
match metric number
•
match tag tag-value
The following set parameters are valid for OSPF redistribution:
•
set ip next hop ipv4-address
•
set metric [+ | - ] number | none
•
set metric-type type-1 | type-2
•
set tag tag-value
NOTE
You must configure the route map before you configure a redistribution filter that uses the route
map.
NOTE
When you use a route map for route redistribution, the software disregards the permit or deny action
of the route map.
NOTE
For an external route that is redistributed into OSPFv3 through a route map, the metric value of the
route remains the same unless the metric is set by a set metric command inside the route map or
the default-metric num command. For a route redistributed without using a route map, the metric is
set by the metric parameter if set or the default-metric num command if the metric parameter is not
set.
Modifying default metric for routes redistributed into OSPF Version 3
The default metric is a global parameter that specifies the cost applied by default to routes
redistributed into OSPFv3. The default value is 0.
If the metric parameter for the redistribute command is not set and the default-metric command is
not set, the metric is set to 1, its default value, then routes redistributed from the various routing
protocols will have the metric value of the protocol from which they are redistributed. For
information about the redistribute command, refer to
“Configuring route redistribution into
NOTE
You also can define the cost on individual interfaces. The interface cost overrides the default cost.
For information about defining the cost on individual interfaces, refer to
“Changing the reference bandwidth for the cost on OSPFv3
To assign a default metric of 4 to all routes imported into OSPFv3, enter the following command.
Brocade(config-ospf6-router)# default-metric 4
Syntax: [no] default-metric number
You can specify a value from 0 – 65535. The default is 0.