Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) - Manual (Page 697)

Multi-Service IronWare Routing Configuration Guide 669
53-1003033-02
Displaying OSPFv3 information
General OSPF configuration information
To indicate whether the Brocade device is operating as ASBR or not, enter the following command
at any CLI level.
Brocade#show ipv6 ospf
OSPFv3 Process number 0 with Router ID 0x10010101(10.1.1.1)
Running 0 days 0 hours 1 minutes 53 seconds
Number of AS scoped LSAs is 3
Sum of AS scoped LSAs Checksum is fabdd4de
External LSA Limit is 250000
Database Overflow Interval is 10
Database Overflow State is NOT OVERFLOWED
Route calculation executed 0 times
Pending outgoing LSA count 0
Authentication key rollover interval 30 seconds
Authentication key add/remove interval 0 seconds
Number of areas in this router is 4
Router is operating as ABR
Router is operating as ASBR, Redistribute: CONNECTED
High Priority Message Queue Full count: 0
BFD is disabled
The output of the show ipv6 ospf command will indicate if the Brocade device is operating as ASBR.
If the device is not operating as ASBR, then there will be no information about redistribution in the
output.
Displaying OSPFv3 area information
To display global OSPFv3 area information for the device, enter the following command at any CLI
level.
Syntax: show ipv6 ospf area [area-id]
You can specify the area-id parameter in the following formats:
• As an IPv4 address, for example, 192.168.1.1.
• As a numerical value from 0 – 2,147,483,647.
The area-id parameter restricts the display to the specified OSPF area.
This display shows the following information.
Brocade# show ipv6 ospf area
Area 0:
Interface attached to this area: loopback 2 ethe 3/2 tunnel 2
Number of Area scoped LSAs is 6
Statistics of Area 0:
SPF algorithm executed 16 times
SPF last updated: 335256 sec ago
Current SPF node count: 3
Router: 2 Network: 1
Maximum of Hop count to nodes: 2
...