Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) - Manual (Page 540)

512 Multi-Service IronWare Routing Configuration Guide
53-1003033-02
BFD for Static Routes
The multi-hop BFD session to the next hop (BFD neighbor) 30.0.0.5 uses the TX and RX intervals of
90ms.
When configuring multi-hop static route and multi-hop bfd neighbor, the protocol by which the
nexthop is to be resolved must be stated using the IP route next-hop command.
Show commands
The show ip static route and show ipv6 static route command output indicates that BFD monitoring
is enabled by the b next to the static route.
Brocade# show ip static route
IP Static Routing Table - 3 entries:
STATIC Codes - b:BFD monitoring
IP Prefix Next Hop Interface Dis/Metric/Tag Name
* 0.0.0.0/0 10.37.73.129 - 1/1/0
0.0.0.0/0 10.37.73.1 - 1/1/0
b 100.0.0.0/8 10.0.0.2 - 1/1/0
b 150.0.0.0/8 20.0.0.3 - 1/1/0
Brocade#
Brocade# show ipv6 static route
IPv6 Static Routing Table - 2 entries:
STATIC Codes - b:BFD monitoring
IPv6 Prefix Interface Next Hop Router Met/Dis/Tag Name
b 100::/64 eth 1/5 10::2 1/1/0
b 150::/64 eth 1/5 20::3 1/1/0
Brocade#
The show bfd applications output indicates that BFD monitoring is enabled by the static and
static6.
Brocade# show bfd applications
Registered Protocols Count: 4
Protocol VRFID Parameter HoldoverInterval
static6 0 1 0
static 0 1 0
bgp 1 0 0
ospf 0 0 0
Brocade#
The show bfd neighbors details output indicates that BFD monitoring is enabled by the static and
static6.
Brocade# show bfd neighbors details 20.0.0.3
NeighborAddress State Interface Holddown Interval R/H
20.0.0.3 UP eth 1/5 300000 100000 Y/M
Registered Protocols(Protocol/VRFID): static/0
Local: Disc: 3, Diag: 0, Demand: 0 Poll: 0
MinTxInterval: 100000, MinRxInterval: 100000, Multiplier: 3
Remote: Disc: 5, Diag: 0, Demand: 0 Poll: 0
MinTxInterval: 100000, MinRxInterval: 100000, Multiplier: 3
Stats: RX: 89596 TX: 87853 SessionUpCount: 1 at SysUpTime: 0:5:10:53.575
Session Uptime: 0:1:0:16.300, LastSessionDownTimestamp: 0:0:0:0.0
Tx Port: eth 1/1(eth 1/1),Rx Port: eth 1/1(eth 1/1)
Using PBIF Assist: Y
Brocade#