Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) - Manual (Page 636)

608 Multi-Service IronWare Routing Configuration Guide
53-1003033-02
show ip bgp vpnv6 neighbors
Examples The following example displays BGP4+ neighbor information:
Brocade(config-bgp-vpnv4u)#show ip bgp vpnv6 neighbors
1 IP Address: 40.0.0.4, AS: 100 (IBGP), RouterID: 4.4.4.4, VRF: default-vrf
State: ESTABLISHED, Time: 0h4m1s, KeepAliveTime: 60, HoldTime: 180
KeepAliveTimer Expire in 31 seconds, HoldTimer Expire in 149 seconds
Minimal Route Advertisement Interval: 0 seconds
RefreshCapability: Received
Address Family : VPNV6 Unicast
SendExtenedCommunity: yes
Messages: Open Update KeepAlive Notification Refresh-Req
Sent : 1 0 5 0 0
Received: 1 0 5 0 0
Last Update Time: NLRI Withdraw NLRI Withdraw
Tx: --- --- Rx: --- ---
Last Connection Reset Reason:Unknown
Notification Sent: Unspecified
Notification Received: Unspecified
Neighbor NLRI Negotiation:
Peer Negotiated VPNv6 unicast capability
Peer configured for VPNv6 unicast Routes
Neighbor ipv6 MPLS Label Capability Negotiation:
Neighbor AS4 Capability Negotiation:
Outbound Policy Group:
ID: 6, Use Count: 1
TCP Connection state: ESTABLISHED, flags:00000033 (0,0)
Maximum segment size: 1460
TTL check: 0, value: 0, rcvd: 64
Byte Sent: 140, Received: 140
Local host: 40.0.0.2, Local Port: 8142
Remote host: 40.0.0.4, Remote Port: 179
ISentSeq: 1305546854 SendNext: 1305546995 TotUnAck: 0
TotSent: 141 ReTrans: 0 UnAckSeq: 1305546995
History
Related
Commands
show ip bgp vpnv6 routes
show ip bgp vpnv6 tags
show ip bgp vpnv6 summary
Release Command History
Multi-Service IronWare R05.5.00 This command was introduced.