Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) - Manual (Page 254)

226 Multi-Service IronWare Routing Configuration Guide
53-1003033-02
Displaying OSPF information
Displaying OSPF route information
To display OSPF route information, enter the following command at any CLI level.
Syntax: show ip ospf routes [ip-addr]
The ip-addr parameter specifies a destination IP address. If you use this parameter, only the route
entries for that destination are shown.
Brocade#show ip ospf route
OSPF Area 0x00000000 ASBR Routes 1:
Destination Mask Path_Cost Type2_Cost Path_Type
10.65.12.1 255.255.255.255 1 0 Intra
Adv_Router Link_State Dest_Type State Tag Flags
10.65.12.1 10.65.12.1 Asbr Valid 0 6000
Paths Out_Port Next_Hop Type State
1 v49 10.1.49.2 OSPF 21 01
2 v12 10.1.12.2 OSPF 21 01
3 v11 10.1.11.2 OSPF 21 01
4 v10 10.1.10.2 OSPF 00 00
OSPF Area 0x00000041 ASBR Routes 1:
Destination Mask Path_Cost Type2_Cost Path_Type
10.65.12.1 255.255.255.255 1 0 Intra
Adv_Router Link_State Dest_Type State Tag Flags
10.65.12.1 10.65.12.1 Asbr Valid 0 6000
Paths Out_Port Next_Hop Type State
1 v204 10.65.5.251 OSPF 21 01
2 v201 10.65.2.251 OSPF 20 d1
3 v202 10.65.3.251 OSPF 20 cd
4 v205 10.65.6.251 OSPF 00 00
OSPF Area Summary Routes 1:
Destination Mask Path_Cost Type2_Cost Path_Type
10.65.0.0 255.255.0.0 0 0 Inter
Adv_Router Link_State Dest_Type State Tag Flags
10.1.10.1 0.0.0.0 Network Valid 0 0000
Paths Out_Port Next_Hop Type State
1 1/1 0.0.0.0 DIRECT 00 00
OSPF Regular Routes 208:
Destination Mask Path_Cost Type2_Cost Path_Type
10.1.10.0 255.255.255.252 1 0 Intra
Adv_Router Link_State Dest_Type State Tag Flags
10.1.10.1 10.1.10.2 Network Valid 0 0000
Paths Out_Port Next_Hop Type State
1 v10 0.0.0.0 OSPF 00 00
Destination Mask Path_Cost Type2_Cost Path_Type
10.1.11.0 255.255.255.252 1 0 Intra
Adv_Router Link_State Dest_Type State Tag Flags
10.1.10.1 10.1.11.2 Network Valid 0 0000
Paths Out_Port Next_Hop Type State
1 v11 0.0.0.0 OSPF 00 00