Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) - Manual (Page 834)

806 Multi-Service IronWare Routing Configuration Guide
53-1003033-02
Displaying VRRP and VRRP-E information for IPv6
Displaying VRRP and VRRP-E information for IPv6
You can display the following information for IPv6 VRRP or VRRP-E:
• “Displaying summary information” on page 806
• “Displaying detailed information” on page 807
• “Displaying statistics” on page 807
• “Displaying configuration information for VRRP and VRRP-E” on page 808
Displaying summary information
To display summary information for IPv6 VRRP or VRRP-E, enter the following command at any level
of the CLI.
Syntax: show ipv6 vrrp [brief | ethernet slot/portnum | statistics | ve num | vrid id]
Syntax: show ipv6 vrrp-extended [brief | ethernet slot/portnum | statistics | ve num | vrid id]
The brief parameter displays the summary information. If you do not use this parameter, detailed
information is displayed instead. Refer to
“Displaying detailed information” on page 802.
The ethernet slot/portnum parameter specifies an Ethernet port. If you use this parameter, the
command displays IPv6 VRRP or VRRP-E information only for the specified port.
The ve num parameter specifies a virtual interface. If you use this parameter, the command
displays IPv6 VRRP or VRRP-E information only for the specified virtual interface.
The vrid id parameter specifies a virtual router ID. If you use this parameter, the command displays
IPv6 VRRP or VRRP-E information only for the specified virtual router.
The statistics parameter displays statistics. Refer to “Displaying statistics” on page 805.
Brocade(config)# show ipv6 vrrp-extended brief
Total number of VRRP routers defined: 1
Flags Codes - P:Preempt 2:V2 3:V3 S:Short-Path-Fwd
Intf VRID CurrPrio Flags State Master-IPv6 Backup-IPv6 Virtual-IPv6
-Address -Address -Address
-------------------------------------------------------------------
1/3 23 100 P3- Master Local 3013::2 3013::99