Displaying ospf router advertisement information, Displaying ospf router advertisement, Information – Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) User Manual
Page 265

Multi-Service IronWare Routing Configuration Guide
237
53-1003033-02
Displaying OSPF information
Graceful Link States
Area Interface Adv Rtr Age Seq(Hex) Prd Rsn Nbr Intf IP
0 eth 1/2 10.2.2.2 7 80000001 60 SW 10.1.1.2
This display shows the following information.
Displaying OSPF Router Advertisement information
Using the show ip ospf command you can display the current OSPF Router Advertisement
configuration. The text show below in bold is displayed for an OSPF Router Advertisement
configuration.
Brocade# show ip ospf
OSPF Version Version 2
Router Id 10.10.10.10
ASBR Status No
ABR Status No (0)
Redistribute Ext Routes from
External LSA Counter 5
External LSA Checksum Sum 0002460e
Originate New LSA Counter 5
Rx New LSA Counter 8
External LSA Limit 14447047
Database Overflow Interval 0
Database Overflow State : NOT OVERFLOWED
RFC 1583 Compatibility : Enabled
TABLE 35
CLI display of OSPF database grace link state information
This field...
Displays...
Area
The OSPF area that the interface configured for OSPF graceful restart is
in.
Interface
The interface that is configured for OSPF graceful restart.
Adv Rtr
ID of the advertised route.
Age
The age of the LSA in seconds.
Seq(Hex)
The sequence number of the LSA. The OSPF neighbor that sent the LSA
stamps the LSA with a sequence number. This number enables the
device and other OSPF routers to determine which LSA for a given route
is the most recent.
Prd
Grace Period: The number of seconds that the router's neighbors should
continue to advertise the router as fully adjacent, regardless of the state
of database synchronization between the router and its neighbors.
Since this time period began when grace-LSA's LS age was equal to 0,
the grace period terminates when either:
•
the LS age of the grace-LSA exceeds the value of a Grace Period
•
the grace-LSA is flushed.
Rsn
Graceful restart reason: The reason for the router restart defined as one
of the following:
•
UK – unknown
•
RS – software restart
•
UP – software upgrade or reload
•
SW – switch to redundant control processor
Nbr Intf IP
The IP address of the OSPF graceful restart neighbor.