Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) - Manual (Page 763)

Multi-Service IronWare Routing Configuration Guide 735
53-1003033-02
Displaying IPv6 IS-IS information
This example contains two mappings for this device. The device’s IS-IS system ID is
“2222.2222.2222“and its hostname is “Router2”. The display contains an entry for another router.
The display contains one entry for each IS that supports name mapping.
NOTE
Name mapping is enabled by default. When name mapping is enabled, the output of the show ipv6
isis database and show ipv6 isis neighbor commands uses the hostname instead of the system ID.
To disable mapping so that these displays use the system ID instead, enter the no hostname
command at the IS-IS router configuration level.
Displaying IPv6 IS-IS interface information
To display information about the interfaces on which IPv6 IS-IS is enabled, enter the following
command at any level of the CLI.
NOTE
The latter part of this display is truncated for brevity. The purpose of this display is to show all
possible fields that might display rather than to show complete output.
Syntax: show ipv6 isis interface
This display shows the following information.
Brocade# show ipv6 isis interface
Total number of IS-IS Interfaces: 4
Interface : 2/1 Local Circuit Number: 00000001
Circuit Type : BCAST Circuit Mode : LEVEL-1-2
Circuit State: UP Passive State: FALSE
MTU : 1497
Level-1 Metric: 10, Level-1 Priority: 64
Level-1 Hello Interval: 10 Level-1 Hello Multiplier: 3
Level-1 Designated IS: Router2.01-22 Level-1 DIS Changes: 8
Level-2 Metric: 10, Priority: 64
Level-2 Hello Interval: 10 Level-2 Hello Multiplier: 3
Level-2 Designated IS: Router2.01-00 Level-2 DIS Changes: 8
Next IS-IS LAN Level-1 Hello in 1 seconds
Next IS-IS LAN Level-2 Hello in 1 seconds
Number of active Level-1 adjacencies: 1
Number of active Level-2 adjacencies: 1
Circuit State Changes: 0 Circuit Adjacencies State Changes: 2
Rejected Adjacencies: 0
Circuit Authentication Fails: 0 Bad LSP 0
Control Messages Sent: 1696 Control Messages Received: 159
IP Enabled: TRUE
IP Address and Subnet Mask:
10.0.0.2 255.0.0.0
10.147.201.150 255.255.255.0
IPv6 Enabled: TRUE
IPv6 Address :
2001:db8::2
. . .