Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) - Manual (Page 321)

Multi-Service IronWare Routing Configuration Guide 293
53-1003033-02
Displaying IPv4 IS-IS information
Displaying the IS-IS configuration in the running-config
You can display the global IS-IS configuration commands that are in effect on the Brocade device
using the following CLI method.
NOTE
The running-config does not list the default values. Only commands that change a setting or add
configuration information are displayed.
To list the global IS-IS configuration commands in the Brocade device’s running-config, enter the
following command at any level of the CLI.
Brocade# show isis config
router isis
net 20.00e0.5200.0001.00
end
The running-config shown in this example contains the command that enables IS-IS and a
command that configures a NET.
To display the interface configuration information in the running-config, enter one of the following
commands at any level of the CLI:
• show running-config
• write terminal
Syntax: show isis config
Global Hello Padding This value can be:
•
Enabled
•
Disabled
Global Hello Padding For Point to Point
Circuits This value can be:
•
Enabled
•
Disabled
Ptpt Three Way HandShake Mechanism This value can be:
•
Enabled
•
Disabled
IS-IS Traffic Engineering Support This value can be:
•
Enabled
•
Disabled
BFD This value can be:
•
Enabled
•
Disabled
Interfaces with IPv4 IS-IS configured Interfaces on which IPv4 IS-IS is configured.
TABLE 39 IS-IS neighbor information (Continued)
This field... Displays...