Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) - Manual (Page 647)

Multi-Service IronWare Routing Configuration Guide 619
53-1003033-02
show ipv6 bgp vrf neighbors
Neighbor IPv6 MPLS
Label Capability
Negotiation Shows the state of the router’s IPv6 MPLS label capability negotiation with the
neighbor. The states can be one of the following:
•
Peer negotiated IPv6 MPLS Label capability
•
Peer configured for IPv6 MPLS Label capability
Neighbor AS4 Capability
Negotiation Shows the state of the router’s AS4 capability negotiation with the neighbor. The
states can be one of the following:
•
Peer negotiated AS4 capability
•
Peer configured for AS4 capability
Outbound Policy Group Shows the ID and the count used in the outbound policy group.
BFD Shows whether or not Bidirectional Forwarding Detection (BFD) is enabled on the
device.
TCP Connection state The state of the connection with the neighbor. The connection can have one of the
following states:
•
LISTEN – Waiting for a connection request.
•
SYN-SENT – Waiting for a matching connection request after having sent a
connection request.
•
SYN-RECEIVED – Waiting for a confirming connection request acknowledgment
after having both received and sent a connection request.
•
ESTABLISHED – Data can be sent and received over the connection. This is the
normal operational state of the connection.
•
FIN-WAIT-1 – Waiting for a connection termination request from the remote TCP,
or an acknowledgment of the connection termination request previously sent.
•
FIN-WAIT-2 – Waiting for a connection termination request from the remote TCP.
•
CLOSE-WAIT – Waiting for a connection termination request from the local user.
•
CLOSING – Waiting for a connection termination request acknowledgment from
the remote TCP.
•
LAST-ACK – Waiting for an acknowledgment of the connection termination
request previously sent to the remote TCP (which includes an acknowledgment of
its connection termination request).
•
TIME-WAIT – Waiting for enough time to pass to be sure the remote TCP received
the acknowledgment of its connection termination request.
•
CLOSED – There is no connection state.
Byte Sent The number of bytes sent.
Byte Received The number of bytes received.
Local host The IP address of the device.
Local port The TCP port the device is using for the BGP4 TCP session with the neighbor.
Remote host The IP address of the neighbor.
Remote port The TCP port the neighbor is using for the BGP4 TCP session with the device.
SentSeq The initial send sequence number for the session.
SendNext The next sequence number to be sent.
TotUnAck The number of sequence numbers sent by the device that have not been
acknowledged by the neighbor.
TotSent The number of sequence numbers sent to the neighbor.
ReTrans The number of sequence numbers that the device retransmitted because they were
not acknowledged.
UnAckSeq The current acknowledged sequence number.
Output field Description