Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) - Manual (Page 653)

Multi-Service IronWare Routing Configuration Guide 625
53-1003033-02
show ipv6 bgp vrf routes
show ipv6 bgp vrf routes
Displays the VRF6 summary statistics for all the VRF6 routes
Syntax show ipv6 bgp vrf vrf-name routes
Parameters vrf-name Specifies the VRF6 name whose route information needs to be displayed.
Command
Modes
Privileged EXEC mode
Usage
Guidelines
The show ipv6 bgp vrf routes command displays the VRF6 route information for all the VRF6 routes
in the device’s BGP4+ route table for a specified VRF.
Command
Output
The show ipv6 bgp vrf routes command displays the following information:
Output field Description
Total number of BGP
Routes The number of BGP4+ routes the Brocade device has installed in the BGP4 route
table.
Status The route status, which can be one or more of the following:
•
A – AGGREGATE.The route is an aggregate route for multiple networks.
•
B – BEST. BGP4 has determined that this is the optimal route to the destination.
NOTE: If the “b” is lowercase, the software was not able to install the route in the IP
route table.
•
b – NOT-INSTALLED-BEST. The routes received from the neighbor are the best
BGP4 routes to their destinations, but were not installed in the IP route table
because the device received better routes from other sources (such as OSPF, RIP,
or static IP routes).
•
C – CONFED_EBGP. The route was learned from a neighbor in the same
confederation and AS, but in a different sub-AS within the confederation.
•
D – DAMPED. This route has been dampened (by the route dampening feature),
and is currently unusable.
•
H – HISTORY. Route dampening is configured for this route, and the route has a
history of flapping and is unreachable now.
•
I – INTERNAL. The route was learned through BGP4.
•
L – LOCAL. The route originated on this device.
•
M – MULTIPATH. BGP4 load sharing is enabled and this route was selected as
one of the best ones to the destination. The best route among the multiple paths
also is marked with “B”.
NOTE: If the “m” is lowercase, the software was not able to install the route in the IP
route table.
•
S – SUPPRESSED. This route was suppressed during aggregation and thus is not
advertised to neighbors.
Prefix The IP address and network mask of the destination network of the route.
AS_PATH The BGP AS_PATH path attribute.
Next Hop The IP address of the next-hop router.
MED The value of the advertised route’s MED attribute. If the route does not have a metric,
this field is blank.