Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) - Manual (Page 608)

580 Multi-Service IronWare Routing Configuration Guide
53-1003033-02
Displaying BGP4+ information
Table 125 provides information about the command output.
TABLE 125 BGP4+ VPNv6 summary information
This field... Displays...
Router ID The device’s ID.
Local AS Number The BGP4+ AS number for the device.
Confederation Identifier The AS number of the confederation in which the device resides.
Confederation Peers The numbers of the local ASs contained in the confederation. This list
matches the confederation peer list you configure on the device.
Maximum Number of IP ECMP Path
Supported for Load Sharing The maximum number of IP ECMP route paths across which the device
can balance traffic to the same destination.
Number of Neighbors Configured The number of BGP4+ neighbors configured on this device, and
currently in established state.
Number of Routes Installed The number of BGP4+ routes in the device BGP4 route table and the
route or path memory usage.
Number of Routes Advertising to All
Neighbors The total of the RtSent and RtToSend columns for all neighbors, the
total number of unique ribout group entries, and the amount of memory
used by these groups.
Number of Attribute Entries Installed The number of BGP4+ route-attribute entries in the device
route-attributes table and the amount of memory used by these entries.
Neighbor Address The IP addresses of the BGP4 neighbors for this device.
AS# The AS number.