Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) - Manual (Page 727)

Multi-Service IronWare Routing Configuration Guide 699
53-1003033-02
Displaying OSPFv3 information
Displaying IPsec for an interface
To see IPsec configuration for a particular interface or all interfaces, use the show ipv6 ospf
interface command as in the following example (IPsec information in bold).
Syntax: show ipv6 ospf interface [ethernet slot/port | loopback number | tunnel number | ve
number]
TABLE 149 Area configuration of IPsec
This field... Displays...
Authentication This field shows whether or not authentication is configured. If this field says
“Not Configured,” the IPsec-related fields (bold in example screen output) are
not displayed at all.
KeyRolloverTime The number of seconds between each initiation of a key rollover. This field
shows the configured and current times.
KeyRolloverState Can be:
Not active: key rollover is not active.
Active phase 1: rollover is in its first interval.
Active phase 2: rollover is in its second interval.
Brocade#show ipv6 ospf interface
eth 1/3 is down, type BROADCAST
Interface is disabled
eth 1/8 is up, type BROADCAST
IPv6 Address:
2001:db8:18:18:18::1/64
2001:db8:18:18::/64
Instance ID 255, Router ID 10.1.1.1
Area ID 1, Cost 1
State BDR, Transmit Delay 1 sec, Priority 1
Timer intervals :
Hello 10, Hello Jitter 10 Dead 40, Retransmit 5
Authentication: Enabled
KeyRolloverTime(sec): Configured: 30 Current: 0
KeyRolloverState: NotActive
Outbound: SPI:121212, ESP, SHA1
Key:1234567890123456789012345678901234567890
Inbound: SPI:121212, ESP, SHA1
Key:1234567890123456789012345678901234567890
DR:10.2.2.2 BDR:10.1.1.1 Number of I/F scoped LSAs is 2
DRElection: 1 times, DelayedLSAck: 83 times
Neighbor Count = 1, Adjacent Neighbor Count= 1
Neighbor:
10.2.2.2 (DR)
Statistics of interface eth 1/8:
Type tx rx tx-byte rx-byte
Unknown 0 0 0 0
Hello 1415 1408 56592 56320
DbDesc 3 3 804 804
LSReq 1 1 28 28
LSUpdate 193 121 15616 9720
LSAck 85 109 4840 4924
OSPF messages dropped,no authentication: 0