Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) - Manual (Page 768)

740 Multi-Service IronWare Routing Configuration Guide
53-1003033-02
Displaying IPv6 IS-IS information
Displaying IPv6 IS-IS redistribution information
To display information about the IPv6 routes redistributed into IPv6 IS-IS, enter the following
command at any level of the CLI.
Syntax: show ipv6 isis redistributed-routes
This display shows the following information.
Displaying the IPv6 IS-IS route information
To display the routes in the device’s IPv6 IS-IS route table, enter the following command at any level
of the CLI.
StateChgeTime For information about this field, refer to Table 157 on page 738.
Area Address(es) The address(es) of areas to which the neighbor interface belongs.
IP Address(es) The IP address(es) assigned to the neighbor interface.
IPv6 Address The IPv6 address(es) assigned to the neighbor interface.
Circuit ID The ID of the IS-IS circuit running on the neighbor interface.
TABLE 159 IPv6 IS-IS redistribution information
This field... Displays...
Prefix The IPv6 routes redistributed into IPv6 IS-IS.
Protocol The protocol from which the route is redistributed into IPv6 IS-IS. Possible
protocols include the following:
•
BGP – BGP4+.
•
RIP – RIPng.
•
OSPF – OSPFv3.
•
Static – IPv6 static route table.
•
Connected – A directly connected network.
Level The IS-IS level into which a route is redistributed. Possible levels include the
following:
•
Level-1
•
Level-2
•
Level-1-2
Metric The value of the default redistribution metric, which is the IS-IS cost of
redistributing the route into IPv6 IS-IS.
TABLE 158 Detailed IPv6 IS-IS neighbor information (Continued)
This field... Displays...
Brocade# show ipv6 isis redistributed-routes
Prefix Protocol Level Metric
2001:db8:1002::/48 Static Level-2 1
2001:db8:2002::/48 Static Level-2 1
2001:db8:3002::/48 Static Level-2 1
2001:db8:4002::/48 Static Level-2 1
2001:db8:5002::/48 Static Level-2 1