Brocade Multi-Service IronWare Routing Configuration Guide (Supporting R05.6.00) - Manual (Page 696)

668 Multi-Service IronWare Routing Configuration Guide
53-1003033-02
Displaying OSPFv3 information
NOTE
You cannot specify a maximum metric value with the include-stub parameter. If you specify
include-stub, point-to-point and broadcast stub links in the intra-area-prefix LSA are advertised at a
value of 65535.
The summary-lsa [max-metric-value] parameter configures the maximum metric value for
inter-area-prefix type-3 and type-4 LSAs. The range is from 1 through 16777215. The default value
is 16711680.
NOTE
Setting the max-metric-value for summary-lsa to 16777215 makes the route unreachable.
The external-lsa [max-metric-value] parameter configures the maximum metric value for external
type-5 and type-7 LSAs. The range is from 1 through 16777215. The default value is 16711680.
NOTE
Setting the max-metric-value for external-lsa to 16777215 makes the route unreachable.
The on-startup {seconds | wait-for-bgp} parameter specifies the advertisement of the maximum
metric for a limited period only, on startup. The seconds variable specifies the length of time in
seconds. The range is from 5 through 86400. The wait-for-bgp parameter specifies that the
maximum metric is advertised until BGP converges or for 600 seconds. When the on-startup option
is not specified, a device configured with max-metric router-lsa always advertises the max-metric.
The no form of the command removes the configuration.
NOTE
The on-startup configuration does not apply to NSR restarts.
Displaying OSPFv3 information
You can display the information for the following OSPFv3 parameters:
• Areas
• Link state databases
• Interfaces
• Memory usage
• Neighbors
• Redistributed routes
• Routes
• SPF
• Virtual links
• Virtual neighbors
• IPsec
• key-add-remove interval