Figure 395 – Brocade Network Advisor SAN User Manual v12.1.0 User Manual
Page 947
Brocade Network Advisor SAN User Manual
899
53-1002948-01
Configuring a switch for FICON operation
25
FIGURE 395
Firmware download
11. Select the switches in the Available Switches panel where you want to download firmware, and
then click the right arrow to move them under Selected Switches.
12. Click Download.
13. Select the Repository tab to import new firmware files for downloads. Refer to the “Firmware
management” section in
Chapter 15, “SAN Device Configuration”
for more information on
importing firmware.
14. If you are not using virtual fabrics or you do not plan to enable virtual fabrics and only use the
. As an option at this point, you can configure virtual fabrics by
referring to procedures in the following sections under “Configuring Virtual Fabrics” in the
“Virtual Fabrics”
.
•
“Enabling Virtual Fabrics”
•
“Creating a logical switch or base switch”
•
“Assigning ports to a logical switch”
For best practices for configuring virtual fabrics, refer to
“FICON best practices for Virtual
Fabrics”
on page 965.
15. To configure the switch as part of a fabric, follow procedures under
on page 909, then return to
.
16. If a name does not display for the switch after configuring the fabric, right click the switch icon
in topology of the SAN tab and select Properties.
The switch Properties dialog box displays.
17. Edit the switch name.