Brocade Network Advisor SAN User Manual v12.1.0 - Manual (Page 779)

Brocade Network Advisor SAN User Manual 731
53-1002948-01
Rekeying all disk LUNs manually
20
.
FIGURE 335 Pending manual rekey operations
Viewing disk LUN rekeying details
You can view details related to the rekeying of a selected target disk LUN from the LUN Re-keying
Details dialog box.
1. Select Configure > Encryption from the menu task bar to display the Encryption Center
dialog box. (Refer to Figure 196 on page 566.)
2. Select a group, switch, or engine from the Encryption Center Devices table, then select
Group/Switch/Engine > Targets, or right-click the group, switch, or engine and select Targets.
NOTE
You can also select a group, switch, or engine from the Encryption Center Devices table, then
click the Targets icon.
The Encryption Targets dialog box displays.
3. Select a Target storage device, then select Group/Switch/Engine > Disk LUNs.
The Encryption Target Disk LUNs dialog box displays. (Refer to Figure 336 .) Initially the list is
empty. You must add LUNs manually.
FIGURE 336 Encryption Target Disk LUNs dialog box