Brocade Network Advisor SAN User Manual v12.1.0 - Manual (Page 883)

Brocade Network Advisor SAN User Manual 835
53-1002948-01
Configuring an FCIP tunnel
22
FIGURE 362 Add FCIP Tunnel dialog box
c. Click Select Switch Two under Switch Two Settings on the Add FCIP Tunnels dialog box to
display the Select Switch dialog box.
The Select Switch dialog box displays discovered Extension Switches.
d. Select the switch you want to connect to switch one and click OK.
e. The switch and fabric names display in the Switch Two Settings area of the Add FCIP
Tunnel dialog box.
f. Enter a description of the tunnel in the Description field.
NOTE
You cannot assign a Tunnel ID until after at least one circuit is configured. The Add Circuit
dialog returns you to the Add FCIP Tunnel dialog to allow you to select the Tunnel ID.
g. Skip to step step 4 and continue configuration.
3. To edit the configuration for an existing FCIP tunnel and circuits between two switches, follow
these steps:
NOTE
You cannot edit an active tunnel; disable the tunnel before making changes.
a. From the FCIP Tunnels dialog box (refer to step 1 ), select the FCIP tunnel that you want to
configure under the Products tree.
b. Click Edit