Adding target disk luns for encryption – Brocade Network Advisor SAN User Manual v12.1.0 User Manual
Page 742
694
Brocade Network Advisor SAN User Manual
53-1002948-01
Adding target disk LUNs for encryption
20
Adding target disk LUNs for encryption
You can add a new path to an existing disk LUN or add a new LUN and path by launching the Add
New Path wizard.
NOTE
Before you can add a target disk LUN for encryption, you must first configure the Storage Arrays. For
more information, see
Complete the following steps to add a target disk LUN:
1. Select Configure > Encryption from the menu task bar to display the Encryption Center
dialog box.
2. Select a group, switch, or engine from the Encryption Center Devices table, then select
Group/Switch/Engine > Disk LUNs from the menu task bar.
The Encryption Disk LUN View dialog box displays. (Refer to
Figure 308
.)
FIGURE 308
Encryption Disk LUN View dialog box
The dialog box provides a convenient way to view and manage disk LUNs that are provisioned
from different hosts, identify conflicts between configuration policies on storage systems, and
to provide a launching point for the Add New Path wizard for configuring multiple I/O paths to
the LUN.
The dialog box contains the following information:
•
Storage Array
selector: Determines which LUN paths are displayed in the table. Enables
you to select a storage array from the LUN view prior to launching the Add New Path
wizard. Only ports that belong to at least one target container are listed.
•
Host selector: Used to select a host from the LUN view prior to launching the Add New Path
wizard. Only ports that belong to at least one target container are listed.
•
Encryption path table: Should be LUN/Path identified by the following:
-
LUN Path Serial #
-
Target Port
-
Initiator Port
-
Container Name
-
Switch Name