Brocade Network Advisor SAN User Manual v12.1.0 - Manual (Page 529)

Brocade Network Advisor SAN User Manual 481
53-1002948-01
DCB configuration
16
7. Click OK.
8. When you have finished the configuration, click OK to launch the Deploy to Products dialog
box.
Configuring LLDP
To configure LLDP, complete the following steps.
1. Select Configure > DCB.
The DCB Configuration dialog box displays.
2. Select the switch to edit from the Product/Ports list and click Edit.
The Edit Switch dialog box displays.
3. Click the LLDP-DCBX tab.
The Edit Switch dialog box - LLDP-DCBX tab displays, as shown in Figure 163 .
FIGURE 163 Edit Switch dialog box - LLDP-DCBX tab
4. Select the Global Configuration LLDP profile in the LLDP Profiles list.
5. Click the left arrow button to edit.
6. Select the FCoE Application and FCoE Logical Link check boxes in the Advertise list to
advertise them on the network.
7. Click OK after changing the attributes of the current deployment.
The Deployment Status dialog box displays.
8. Click Start on the Deployment Status dialog box to save the changes to the switch.
9. Click Close to close the Deployment Status dialog box.