Brocade Network Advisor SAN User Manual v12.1.0 - Manual (Page 913)

Brocade Network Advisor SAN User Manual 865
53-1002948-01
Fabric Binding overview
23
Adding switches to the fabric binding membership list
Once you have enabled Fabric Binding (refer to “Enabling fabric binding” on page 863), you can
add switches to the fabric binding membership list.
NOTE
Fabric Binding is only supported on Fabric OS 5.2 or later.
To add a switch to the fabric, complete the following steps.
1. Select Configure > Fabric Binding.
The Fabric Binding dialog box displays ( Figure 380 ).
2. Select the switches you want to add to the selected fabrics’ Fabric Membership List (FML) in
the Available Switches table.
3. Click the right arrow to move the switches to the Membership List table.
4. Click OK on the Fabric Binding dialog box.
Adding detached devices to the fabric binding membership list
To add a switch that does not have a physical connection and is not discovered to the fabric,
complete the following steps.
1. Select Configure > Fabric Binding.
The Fabric Binding dialog box displays ( Figure 380 ).
2. Click Add Detached Switch.
The Add Detached Switch dialog box displays.
3. Enter the domain ID of the switch in the Domain ID field.
4. Enter the nodeworld wide name (WWN) of the switch in the Node WWN field.
You can copy (Ctrl+C) and paste (Ctrl+V) the Node WWN into the Node WWN field. It does not
matter if the copy source contains colons (11:22:33:44:55:66:77), only the numbers are
pasted (11223344556677) in the Node WWN field.
5. Click OK on the Add Detached Switch dialog box.
The added switch displays in the Membership List of Fabric_Name table on the Fabric Binding
dialog box.
6. Click OK on the Fabric Binding dialog box.