Brocade Network Advisor SAN User Manual v12.1.0 - Manual (Page 466)

416 Brocade Network Advisor SAN User Manual
53-1002948-01
Port Auto Disable
12
Port Auto Disable
NOTE
Port Auto Disable requires devices running Fabric OS 6.3 or later.
Port Auto Disable (PAD) allows you to enable and disable Port Auto Disable on individual FC_ports
or on all ports on a selected device, as well as unblock currently blocked ports. Enabling port auto
disable on a port or device configures ports to become blocked when any of the following five
events occur:
• Loss of Sync
• Loss of Signal
• OLS (Offline Primitive Sequence)
• NOS (Not Operational Primitive Sequence)
• LIP (Loop Initialization Primitive Sequence)
For Fabric OS devices running 7.0 or later, you can configure ports to become blocked when a
specific event is triggered (one or more of the events listed above).
You can also suspend or resume Port Auto Disable on a switch.
Viewing Port Auto Disable status
NOTE
Port Auto Disable requires devices running Fabric OS 6.3 or later.
To view the PAD status, complete the following steps.
1. Select Monitor > Port Auto Disable.
The Port Auto Disable dialog box displays.