Brocade Network Advisor SAN User Manual v12.1.0 - Manual (Page 780)

732 Brocade Network Advisor SAN User Manual
53-1002948-01
Rekeying all disk LUNs manually
20
4. Click Add.
The Add Disk LUNs dialog box displays. This dialog box includes a table of all LUNs in the
storage device that are visible to the hosts.
5. Click Re-keying Details.
The LUN Re-keying Details dialog box displays. The dialog box contains the following
information:
• Key ID: The LUN key identifier.
• Key ID State: The state of the LUN rekeying operation.
• Encryption Algorithm: The algorithm of the LUN rekeying operation.
• Re-key Session Number: The session number of the LUN rekeying operation.
• Re-key Role: The role of the LUN rekeying operation.
• Re-key State: The state of a manual LUN rekeying operation. Options are:
- Read Phase
- Write Phase
- Pending
- Disabled
• Block Size: The block size used on the LUN.
• Number of Blocks: The number of blocks written.
• Current LBA: The Logical Block Address (LBA) of the block that is currently being written.
• Re-key Completion: The status of the LUN rekeying operation’s progress.
Viewing the progress of manual rekey operations
To monitor the progress of manual rekey operations, complete these steps:
1. Select Configure > Encryption from the menu task bar to display the Encryption Center
dialog box. (Refer to Figure 196 on page 566.)
2. Select an encryption group from the Encryption Center Devices table, then select Group >
Re-Key Sessions from the menu task bar.
The Re-Key Sessions Status dialog box displays, which enables you to check on the status of
each LUN that is being rekeyed within an encryption group. (Refer to
Figure 337 .)