Brocade Network Advisor SAN User Manual v12.1.0 - Manual (Page 1238)

Brocade Network Advisor SAN User Manual 1191
53-1002948-01
MAPS actions
34
Viewing MAPS policy rules
You can open more than one View Policy dialog box at the same time.
1. Right-click a device in the Product List or Connectivity Map and select Fabric Vision > MAPS >
Configure.
The MAPS Configuration dialog box displays.
2. Select a policy and click View.
You can also select the switch in the list and select View to view the active policy. The View
Policy dialog box displays (
Figure 495 ).
FIGURE 495 View Policy dialog box
3. Select one of the category tabs to view the rules defined for the policy.
For a complete list of categories and the associated measures and actions, refer to “MAPS
categories, measures, and actions” on page 1166. Options include:
• Port tab — Rules defined on this tab measure thresholds on ports or SFPs to determine if
an out of range violation is sent for the port.
• Switch Status tab — Rules defined on this tab measure thresholds at the switch or chassis
level to determine the switch operational status.
• Fabric tab — Rules defined on this tab measure thresholds at the switch level to detect out
of range fabric-wide changes.
• FRU tab — Rules defined on this tab measure thresholds on fans, power supplies, SFPs,
blades, or WWN cards to detect out of range FRU changes.