H3C Technologies H3C Intelligent Management Center User Manual
Page 592
578
2.
Modify the device label for this device in the Device Label field of the Configure Device Information
section.
3.
Select the device group to which you want to modify this device from the Device Group list of the
Configure Device Information section.
You must create device groups before you can modify devices in them. Once you have created the
device groups, they appear in the Device Group list.
4.
Select the login type for this device from the Login Type list of the Configure Device Information
section.
This parameter does not take effect on a device that has been added to IMC.
5.
If you want IMC to process traps sent by this device for alarming and notification purposes, verify
that the checkbox to the left of Automatically register to receive SNMP traps from supported
devices is checked .
IMPORTANT:
If the Automatically register to receive SNMP traps from supported devices checkbox is not checked,
IMC cannot process, display, or alarm on traps sent by this device.
6.
If this device to be modified responds to ping requests for monitoring reachability, verify that the
checkbox to the left of Support Ping Operation is checked.
If this device does not respond to ping requests, verify that the checkbox is unchecked .
7.
To configure the device additional information, select the checkbox next to Set Appended
Information for Device and set the device additional information value.
This option is available only when you have configured the device additional information. For
more information about configuring device additional information, see "
8.
Do one of the following:
{
If you want to modify the Access Parameters, For information about the operations, see "
an automatic deployment device
." The method of modifying the access parameters is the same
as that described in "
Adding an automatic deployment device
{
If you do not, go to Step9.
9.
Click OK to complete the operation of modifying the automatic deployment device.
Review the results of the modification operation in the Auto Deployment Plan page.
Importing devices into an automatic deployment plan
IMC provides you with the ability to batch import device information from a file to an automatic
deployment plan.
The file must be in CSV format. The first line in the file is the column headings, and all the other lines are
the corresponding values. The following table, shown in
describes these columns.
Table 29 Columns in a CSV file
Column heading
Description
Required
TargetIp
IP address of the device after the selected configuration file is
deployed on the device.
Yes
ConfigFile
Name of the configuration file to be deployed on the device.
Yes