H3C Technologies H3C Intelligent Management Center - Manual (Page 139)

125
8. Select the SNMPv3 type that matches the version of SNMP configured on the devices to be
managed by this template from the Parameter Type list, shown in Table 2 .
Table 2 SNMP parameters
Parameter type option Description
SNMPv1 SNMP version 1
SNMPv2c SNMP version v2c
SNMPv3 No-Priv No_Auth SNMPv3 with no authentication and no encryption
SNMPv3 No-Priv Auth-Md5 SNMPv3 with no encryption and with MD5 authentication
SNMPv3 No-Priv Auth-Sha SNMPv3 with no encryption and with SHA authentication
SNMPv3 Priv-Des Auth-Md5 SNMPv3 with DES encryption and Md5 authentication
SNMPv3 Priv-Des Auth-Sha SNMPv3 with DES encryption and SHA authentication
SNMPv3 Priv-Aes128 Auth-Md5 SNMPv3 with Aes 128 bit encryption and Md5 authentication
SNMPv3 Priv-Aes128 Auth-Sha SNMPv3 with Aes 128 bit encryption and Sha authentication
SNMPv3 Priv-Aes192 Auth-Md5 SNMPv3 with Aes 192 bit encryption and Md5 authentication
SNMPv3 Priv-Aes192 Auth-Sha SNMPv3 with Aes 192 bit encryption and Sha authentication
SNMPv3 Priv-Aes256 Auth-Md5 SNMPv3 with Aes 256 bit encryption and Md5 authentication
SNMPv3 Priv-Aes256 Auth-Sha SNMPv3 with Aes 256 bit encryption and Sha authentication
9. Enter the username that is configured on the managed devices in the Username field.
10. If prompted, enter the authentication password that is configured on the managed devices in the
Authentication Password field.
11. If prompted, enter the encryption password that is configured on the managed devices in the
Encryption Password field.
12. Enter the SNMP timeout value in the Timeout field.
Valid range is 1–60 seconds. The timeout parameter defines how long the system waits for the
device to respond to SNMP requests before reporting that the request has timed out.
13. Enter the SNMP retries value in the Retries field.
Valid range is 1–20. The retries parameter defines how many times the management system (IMC)
sends SNMP retries in an attempt to communicate with the managed device. The default is 3.
14. Click OK.
The SNMP templates you have created now appear as configuration options when adding devices to
IMC by auto discovery, by batch mode or by adding devices individually. For more information, see
" Adding devices in IMC ."
Modifying an SNMP template
To modify an SNMP template:
1. Navigate to System > SNMP Template:
a. Click the System tab from the tabular navigation system on the top.
b. Click Resource Management on the navigation tree on the left.
c. Click SNMP Template under Resource Management from the navigation system on the left.