H3C Technologies H3C Intelligent Management Center - Manual (Page 491)

477
Configuration Center supports the following services and actions (the action name cannot be modified):
• Configuration backup (ConfigBackup)
• backup_running_config
• backup_startup_config
• Configuration deployment (ConfigDeploy)
• deploy_running_config
• deploy_startup_config
• save_config
• reload_device
• Software deployment (ImageDeploy)
• deploy_image
• delete_image
• set_device_boot
• get_image_version
• get_image_position
• get_image_size
• get_partion_info
You must note the following guidelines when you define services for Configuration Center:
• If you have defined the ConfigBackup service in the adapter.xml file, you must define
backup_running_config, backup_startup_config, or both. These actions are executed during device
configuration backup.
• If you have defined the ConfigDeploy service in the adapter.xml file, you must define
deploy_running_config, deploy_startup_config, or both; you must define save_config and
reload_device.
• When you deploy configurations, the deploy_running_config or deploy_startup_config action,
based on your configuration, is executed. If no action is defined, the system prompts that
deploy_running_config or deploy_startup_config is not supported. During deployment, both the
deployment and save actions are executed. To specify the restart action, select Restart device after
deployment on the Deploy Strategy page.
• If you have defined the ImageDeploy service in the adapter.xml file, you must define deploy_image,
set_device_boot, and delete_image; the actions get_image_position, get_image_version,
get_image_size, and get_partion_info are optional.
• When you deploy device software, deploy_image is executed; to execute set_device_boot and
delete_image, make the settings as shown on the following page.
• Set the Current Running Software as Backup Startup Software and Delete Current Backup Startup
Software are not supported. These actions are not executed even if you have selected them.
• The actions get_image_version and get_partion_info are used during software deployment. The
get_partion_info action retrieves partition name and the available space. If these actions are not
defined, the system asks you to enter the storage location, and perform software deployment
without checking the available space (the default space is sufficient).
• After deployment, the get_image_size action is executed to check the software size and deployment
result. If this action is not defined, the checking is not performed.