H3C Technologies H3C Intelligent Management Center - Manual (Page 247)

233
e. Retries: Enter the number of SNMP retries (1–20) in the Retries field. The retries parameter
defines how many times the management system (IMC) sends SNMP retries in an attempt to
communicate with the managed device before reporting a failure. The default is 3.
Using existing SNMP template
To configure the SNMP settings for this device using an SNMP template:
1. Click the radio button to the left of Select an Existing Template.
2. Click the radio button to the left of the SNMP template you want to use.
3. Click OK.
4. To configure the Telnet settings, click the configure icon located at the Telnet Parameters
section.
The Telnet Parameters dialog box appears.
You can either enter the Telnet settings in this dialog box or select an existing Telnet template that
contains the Telnet settings for this device. Telnet templates are particularly useful when Telnet
configurations are standardized. For more information about creating Telnet templates, see
" Telnet templates ."
Editing Telnet settings manually
1. To edit the Telnet parameters manually, verify that the radio button to the left of Edit Telnet
Parameters is selected.
2. Do the following:
a. Authentication Mode: Select the mode that corresponds with the Telnet authentication mode
configured on the managed devices from the Authentication Mode list.
b. Username: Enter the username configured on managed devices in the Username field, if
prompted.
c. Password: Enter the password configured on the managed devices in the Password field, if
prompted.
d. Super Password: Enter the super password configured on the managed devices for the Super
Password, if prompted.
e. Timeout: Enter the Telnet timeout value (1–60 seconds). The timeout parameter defines how
long the system waits for the device to respond in seconds.
Using existing Telnet template
1. To configure the Telnet settings for this device using Telnet templates, click the radio button to
the left of Select an Existing Template.
2. Click the radio button to the left of the Telnet template you want to use.
3. Click OK.
4. To configure the SSH settings, click the configure icon located to the right of SSH Parameters.
The SSH Parameters dialog box appears.
You can either enter the SSH settings in this dialog box or select an existing SSH template that
contains the SSH settings for this device. SSH templates are useful when SSH configurations are
standardized. For more information about creating SSH templates, see " SSH templates ."
Editing SSH settings manually