Basler Electric DECS-250N - Manual (Page 337)

9440500990 Rev D 321
DECS-250N Analog Expansion Module
CE Compliance
This product has been evaluated and complies with the relevant essential requirements set forth by the
EU legislation.
EC Directives:
•
LVD 2014/35/EU
•
EMC 2004/108/EC
Harmonized standards used for evaluation:
•
EN 50178
•
EN 61000-6-4
•
EN 61000-6-2
Physical
Weight ........................................ 1.80 lb (816 g)
Dimensions................................. See Installation later in this chapter.
Installation
Analog Expansion Modules are delivered in sturdy cartons to prevent shipping damage. Upon receipt of a
module, check the part number against the requisition and packing list for agreement. Inspect for
damage, and if there is evidence of such, immediately file a claim with the carrier and notify the Basler
Electric regional sales office, your sales representative, or a sales representative at Basler Electric,
Highland, Illinois USA.
If the device is not installed immediately, store it in the original shipping package in a moisture- and dust-
free environment.
Mounting
Analog Expansion Modules are contained in a potted plastic case and may be mounted in any convenient
position. The construction of an Analog Expansion Module is durable enough to mount directly on a
genset using ¼-inch hardware. Hardware selection should be based on any expected
shipping/transportation and operating conditions. The torque applied to the mounting hardware should not
exceed 65 in-lb (7.34 N•m).
See Figure 168 for AEM-2020 overall dimensions. All dimensions are shown in inches with millimeters in
parenthesis.