Basler Electric DECS-250N - Manual (Page 143)

9440500990 Rev D 127
DECS-250N BESTCOMSPlus ® Software
Connect a USB Cable
The USB driver was copied to your PC during BESTCOMSPlus installation and is installed automatically
after powering the DECS-250N. USB driver installation progress is shown in the Windows Taskbar area.
Windows will notify you when installation is complete.
Connect a USB cable between the PC and your DECS-250N. Apply operating power (per style chart in
the Introduction chapter) to the DECS-250N at rear terminals A, B, and C. Wait until the boot sequence is
complete.
Caution
In accordance with the guidelines defined in USB standards, the USB
port on this device is not isolated. To prevent damage to a connected
PC or laptop, the DECS-250N must be properly tied to ground.
Start BESTCOMSPlus ® and Activate DECS-250N Plugin Automatically
To start BESTCOMSPlus, click the Start button, point to Programs, Basler Electric, and then click the
BESTCOMSPlus icon. During initial startup, the BESTCOMSPlus Select Language screen is displayed
(Figure 113). You can choose to have this screen displayed each time BESTCOMSPlus is started, or you
can select a preferred language and this screen will be bypassed in the future. Click OK to continue. This
screen can be accessed later by selecting Tools and Select Language from the menu bar.
Figure 113. BESTCOMSPlus Select Language Screen
The BESTCOMSPlus splash screen is shown for a brief time. See Figure 114.