Metrohm 900 Touch Control Manual - Manual (Page 96)

11.1 Adding a new device
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
80 ￭￭￭￭￭￭￭￭
900 Touch Control
11.1 Adding a new device
Of the following device types, you can enter one device each in the device
list, even if it is not yet connected:
￭ Titrando (three instruments maximum)
￭ USB Sample Processor
￭ Balance
￭ Barcode reader
￭ USB/RS-232 adapter
￭ PC keyboard
Proceed as follows to do this:
1 Displaying the device selection
Tap on [New].
2 Selecting the instrument
Tap on the button for the desired device.
The new device is entered in the list.
11.2 Configuring the instrument
Instrument list: Instrument ▶ Edit
The data stored for an instrument depends on the type of instrument. You
can define an instrument name and a comment for each instrument. The
instrument name of the Touch Control is printed out in the standard
report header.
The description of the individual instruments can be found in the follow-
ing specific chapters:
￭ Touch Control (see Chapter 11.3, page 81)
￭ Metrohm control instruments (see Chapter 11.4, page 87)
￭ USB Sample Processor (see Chapter 11.5, page 91)
￭ Printer (see Chapter 11.7, page 108)
￭ Balance (see Chapter 11.8, page 112)
￭ PC keyboard (see Chapter 11.10, page 115)
￭ USB/RS-232 adapter (see Chapter 11.9, page 114)
￭ Barcode reader (see Chapter 11.11, page 117)