Metrohm 900 Touch Control Manual - Manual (Page 483)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
29 Parameters
900 Touch Control
￭￭￭￭￭￭￭￭ 467
Cancel determination
The determination is stopped.
29.16.4 Defining RS-232 commands (CONTROL RS)
The command CONTROL RS can be used to define the RS-232 com-
mands which are sent.
Serial port
Selection of the serial interface the peripheral device is connected to. The
RS-232 command defined is sent via this interface.
Selection COM1 | COM2 | COM3 | COM4 | COM5 |
COM6 | COM7 | COM8
Default value COM1
Character string
Input of the RS-232 command as character string. All characters of the
ASCII code page can be used. Control characters (Esc, FF etc.) have to be
entered as a three-place, decimal ASCII code, starting with a slash. Each
command is automatically terminated with the ASCII characters CR and
LF.
Entry ASCII string with a max. of 24 characters
Default value &M;$G
29.17 Automation
29.17.1 Rotating sample rack (MOVE)
The command MOVE is used to move to a rack position or an external
position.
Tower
Selection of the tower, with which the command is carried out. Both
Tower 1 and Tower 2 can always be selected, even if your Sample Pro-
cessor has only one tower.
Selection 1 | 2
Default value 1
1
View from the front, the right tower.
2
View from the front, the left tower.
Destination
Selection of the required target position.