Metrohm 900 Touch Control Manual - Manual (Page 209)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
20 Sample data
900 Touch Control
￭￭￭￭￭￭￭￭ 193
Identification 2
Sample identification. The sample identification can be used in calculations
as the variable CI2. If you have defined a sample identification list (see
Chapter 15.1.1, page 146) then the entries can be selected here.
Entry 24 characters maximum
Default value empty
Sample size
Sample size. The value of the sample size can be used in calculations as
the variable C00.
Input range –99999999 - 9999999999
Default value 1.0
Unit of sample size.
Entry 6 characters maximum
Selection g | mg | µg | mL | µL | pieces
Default value g
Unit defined in method:
The unit defined in the method is ignored. The unit entered in the sample
table is used.
Balance connected and configured:
Value from the connected balance.
Fixed sample size defined in method:
The value will be entered in the corresponding line when the method is
loaded. The existing entry will be overwritten.
20.2 Requesting sample data at the start of the determi-
nation
The sample data can be automatically requested immediately after the
start of the determination in order to ensure that the sample data entry is
not forgotten. This automatic inquiry is requisite for reweighing.