Metrohm 900 Touch Control Manual - Manual (Page 115)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
11 Device manager
900 Touch Control
￭￭￭￭￭￭￭￭ 99
11.6 Sample racks
List of devices: Sample Processor ▶ Edit ▶ Racks
In the dialog Edit device / Sample racks, you will find the list of config-
ured racks. The attached rack is displayed in green. New racks can be loa-
ded or created and existing ones can be edited or deleted in this dialog
window.
The following data is displayed in the list:
￭ Rack
Name of the sample rack. Metrohm standard racks are designated by
their order numbers.
￭ Positions
Number of positions on the rack.
￭ Code
The rack code corresponds to the alignment of magnets on the under-
side of the rack and is read out by the Sample Processor for rack recog-
nition.
[Load]
Load a new sample rack (see "Loading the sample rack", page 100).
[Copy]
Create a new sample rack by copying an existing rack (see "Creating a
new sample rack", page 101).
[Delete]
Delete the selected sample rack from the list.
[Edit]
Edit the data of the selected sample rack (see Chapter 11.6.1, page 101).